User`s manual

Before using the appliance for the first
time, you should be informed of the
following tips.
Ventilation of appliance
In order to improve efficiency
of the cooling system and
save energy, it is necessary to
maintain good ventilation around the
appliance for the dissipation of heat.
For this reason, sufficient clear space
should be available around the
refrigerator.
Suggest: It is advisable for there to be
at least 75mm of space from the back
to the wall, at least 100mm from its top,
at least 50mm from its side to the wall
and a clear space in front to allow the
doors to open 135°. As shown in follow
diagrams.
Note:
This appliance performs well
within the climate class showed in
the table below.
It may not work properly if being
left at a temperature above or below
the indicated range for a long period.
Climate class
Ambient temperature
SN
N
ST
T
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
●
●
Stand your appliance in a dry place
to avoid high moisture.
Keep the appliance out of direct
sunlight， rain or frost. Stand the
appliance away from heat sources such
as stoves, fires or heaters.
●
●
Leveling of appliance
For sufficient leveling and air
circulating in the lower rear section of
the appliance, the bottom feet may
need to be adjusted. You can adjust
them manually by hand or by using a
suitable spanner.
To allow the doors to self-close, tilt
the top backwards by about 10mm.
●
●
≤10mm
Installing the door handles
For the convenience of transportation,
the door handles are separately
provided in a plastic bag, you can
install the door handles as follows.
1. Lever screw covers on the left side
of the door, and then put them back to
the plastic bag.
2. Match the handle on the left side of
the door, keeping axes of screw holes
in the handle and the door in a line, as
the picture shows.
3. Fix the handle with the special
screws provided in the plastic bag. And
then install the handle covers.
1
2
Hisense Refrigerator
Installing your new appliance
5
Note:Install the handle cover as the
follow figure shows :button the
buckle firstly , and then close the
cover from the inside until you hear
the sound of "popping" .
≥ 100mm
1855mm
≥ 75mm
≥ 50mm ≥ 50mm
712mm
1220mm
1025mm