User Manual

• 2 phase conductors, 2 neutral conductor (220-240V 2 2N ~

/50/60Hz):

 Voltage between lines and neutral conductor is 220–240V~.

 The circuit should be fitted with at least two fuses of at least

16A each. Power cord core cross-sectional area should be at

least 1.5mm

Appliances with a width of 30 centimetres (two cooking zones)

only allow single-phase connection. The cross-sectional area of

the power cord core should be at least 1.5mm

CONNECTING THE POWER CORD

(appliance witha power cord)

• The appliance has to be hard-wired directly to the power mains.

• Devices for disconnecting from the power mains have to comply with the relevant

regulations.

• Do not extend the power cord and do not lead it over sharp edges.

• If the appliance is installed above an oven, make sure the power cord is never in contact

with the oven's hot parts.

Single-phase connection

• Connect the appliance as shown in Diagram A. If your power mains do not allow a 32A

fuse, the appliance power should be decreased or limited accordingly.

• See chapter SETTING THE MAXIMUM TOTAL APPLIANCE POWER.

L = brown

N = blue

= yellow-green

785435