Operating Guide

Setting the Controls
Control Panel
Starting/Stopping the Dehumidifier
Control Type1
Control Type3
Control Type2
6
DEHUMIDIFIER USE
MANUAL SET
AUTO DRY
MED
HIGH
LOW
EMPTY BUCKET
TIMER MODE POWER CLEAN FILTER FAN PUMP
QUIET
SUPER DRY
NOTE:
■
■
The control panel of your model may differ from
the one shown above.
Pump button may not be displayed on the panel
if your model does not have these functions.
NOTE:
■ Before turning on the dehumidifier, be sure that
the bucket is empty and fits all the way into the
dehumidifier.
■ Each time you unplug the dehumidifier or power
is interrupted, the controls will return to the
previous settings when power is restored.
■ Humidity displayed is between 30% Relative
Humidity and 90% Relative Humidity.
■ Humidity can be set between 30% Relative
Humidity and 80% Relative Humidity.
■ It's important to set the desired humidity level
to an achievable setting. To ensure energy-
efficient operation, only use the dehumidifier in
a closed space, with no open windows or other
sources of moist air (to avoid continuous running).
■ Operating temperature is between 38ºF to 90ºF
(3.2ºC to 32.2ºC).
At temperatures of 38ºF(3.2ºC)or less,
water freezes inside the product. At
temperatures over 90ºF(32.2ºC),the internal
temperature of the product trips a protective
device which deactivates the product to avoid
product damage.
■ The compressor has a 3-minute delay
before restarting. If the product is stopped
The dehumidifier should be
upright for at least 2 hours before use.
and immediately restarted, to protect the
compressor there is a 3-minute delay until
the compressor restarts.
■ When the dehumidifier is operating, the
indoor temperature will rise.
The dehumidifier does not have a cooling
/heating function.
Heat is generated during operation, so the
room temperature may be increased by
about 6ºF(3ºC) depending on the usage
conditions (indoor temperature, size of the
room).
1. Plug into a grounded three-prong outlet.
2. Press POWER to turn on the dehumidifier.
3. Press FAN to choose the fan speed.
4. Press MODE to choose the mode.
5. Press the plus or minus button to set the level
of humidity.
6. Press POWER to turn off the dehumidifier.
If this light is on, the fan and the compressor will
stop running.This light indicates that you need
to check:
Empty Bucket Light
■ If the bucket is full, empty and re-install
bucket.
■ If the bucket is not in position, remove the
bucket and re-install it. Make sure the
bucket fits all the way into the dehumidifier
and the bucket light is off, or dehumidifier
will not run.
NOTE:
In the case of a power outage or interruption, the
dehumidifier will automatically restart, in the
settings last used, after the power is restored.
CONTINUOUS
MANUAL SET
AUTO DRY
MID
HIGH
LOW
EMPTY BUCKE Y
TIMER MODE POWER CLEAN FILTER FAN PUMP
CONTINUOUS
MANUAL SET
AUTO DRY
MID
HIGH
LOW
EMPTY BUCKE Y
TIMER MODE POWER CLEAN FILTER FAN