Operating Guide

Timer
To set Timer for a 30-minute to 24-hour delay
before the dehumidifier is turned off (the
dehumidifier must be On):
1.Press TIMER. Timer indicator light will come
on, and the display will flash. The display will
show remaining time before the dehumidifier
will turn off.
8
2. Press the Plus or Minus button to change the
delay time, from 30 minutes to 24 hours.
To set Timer to turn on the dehumidifier, with
previous setting:
To clear the Timer delay program:
To see the remaining time.
1. Press TIMER once after it has been
programmed. Display will show remaining time.
2. While the display is showing the remaining
time, press TIMER again. Timer indicator light
will turn off.
Press TIMER once after it has been programmed.
Display will show remaining time.
NOTE:
Dehumiditier can be either on or off.
NOTE:
Empty the drain water bucket before setting the
timer function. If the water bucket becomes full
during the Timer function, the Empty Bucket light
goes on and dehumidification stops.
Pump (for Pump function model only)
This feature pumps water horizontally or
vertically. Pump water to a drain, out a window
or anywhere you think suitable.
If the drain hose is not correctly connected to the
unit or is bent, the pump light will flash and the
pump system will not work. See “Trouble shooting”
for direction.
■
IMPORTANT:
You must connect the drain hose to the unit
before pressing the Pump button, or the
pump will not operate. See “Pump drain” for
connecting instructions.
1. Press PUMP to activate the pump system for
active drainage.
2. Once the pump button is pressed, the pump light
will switch on.
NOTE:
■
If the pump light flashes, it means that the pump is not
functioning properly.
P
Site for installing hose for pump function:
Hose length is
16 feet Max.
Dehumidifier
Water
Container
NOTE:
When the light is on, it will remain on for 180
hours or until you press Clean Filter button.
1. When the Clean Filter indicator light is on,
remove, clean and replace the air filter. See
“Cleaning the Air Filter”.
2. Press the Clean Filter button to reset the filter
monitor.
Clean Filter
1. Turn off the dehumidifier.
2. Press TIMER. Timer indicator light will flash.
The display will show remaining time before
the dehumiditier will turn on.
3. Press the Plus or Minus button to change the
delay time, from 30 minutes to 24 hours.
Height should
be less than
16 feet