INSTALLATION GUIDE Hi sense Laser TV Sonic Screen Before you Install this product, read this guide completely and make sure you understand all of the content.
WARNING: Please follow the instructions strictly, or it may cause serious injury or even death. NOTE: Please follow the instructions strictly, or it may cause injury and product damage. + The product should be installed by professional and technical personnel, and by following the installation guide. Installing the product by unqualified personnel is dangerous and may cause personal injury. + The product should be Installed at the place that can support Its weight.
1.1 Required Tools to Install the Screen © mms Stud finder Pencil 0 Drilling tool and 8mm Hammer for anchor bolts Phillips screwdriver Tape drill bit for stud 1.2 Hardware and Parts List for Screen Mounts Magnet spacer (x2) ~~ Wall mount bracket (x2) 8mm anchor bolt (x6) Screw (M6x70) (x6) O Wall mount bracket rub Magnet (x6) Foam spacer (x4) ber spacer (x2) Cable clamp {x3} NOTE Please check hardware and parts in accessories before installing.
1.3 Check the Type of Wall You Have Wall with Wall with Solid concrete or wood studs metal studs concrete black wall Minimum wood stud size: Minimum metal stud size: Minimum solid concrete thickness: common 51 x 102 mm common 51 x 102 mm 203 mm nominal nominal Minimum concrete block size: 203 x 203 x 406 mm 1.4 Prepare Your Space Check the size of your space + Width 22.0m + Height 2 1.7m from the installation surface to the ceiling.
2.1 Secure Anchor Bolts Make sure you have your tape measure, stud finder, hammer, pencil, tape and drilling tool. 1. Starting from the fop of your TV stand, add 137.5¢m above It to get the height of the upper holes of wall mount brackets. Mark the height onto the wall. . Use a stud finder to find the studs in the areas on the wall, and mark the center of the studs with a pencil.
2.2 Install the Wall Mount Brackets and Magnet Spacers Make sure you have your screwdriver. 1. Install two brackets with screws and wall mount bracket rubber spacers. It is recommended to secures the wall mount brackets with the fifth hole from the top and the fifth hole from the bottom. The wall mount brackets must be installed with rubber spacers. Hold bracket in place when tightening the screw to keep the bracket from shifting. 4 Install the brackets with the screws 2. Secure magnet spacers with screws.
3 Hang the Screen 1. Check the up and down direction of the screen. To make sure the orientation of the screen is correct, check the 'UP* label on the back cover of the screen. When your Laser TV is placed on a flat surface {Figure a), the screen should be installed in its normal direction and the arrow of 'UP' label points up (Figure b). Please see the illustrations below.
