Read the manual carefully and ensure you have fully understood its contents before operating this device for the first time.
Read the manual carefully and ensure you have fully understood its contents before operating this device for the first time.
Important Safety Instructions ▐ Important Notice Paragraphs beginning with the symbol conditions for the following settings. indicate important instructions, tips or For your own safety and the optimal performance of your TV, ensure to read the safety instructions before performing any installation. Compatibility with 3rd party products, software and services are not guaranteed. We cannot be held liable for any damage or loss suffered whilst operating, using or connecting to incompatible devices or apps.
Important Safety Instructions The intended use and ambient conditions for this TV This TV is intended for the rendering of video and audio signals, on a table-top or wallmounted, in a home or office environment. It must not be used in rooms with a high level of humidity or dust concentration. The warranty is only valid if used as intended by the manufacturer. WARNING High humidity and dust concentration may lead to current leaks in the device.
Important Safety Instructions Moving/Transportation Power plug and power cable Before moving this TV, disconnect all cables and move in the vertical position only. Grasp the device on the upper and lower edges of the frame. - Do not touch the power plug with wet hands. - Do not place heavy objects on the power cable. Route the cable so that it is not kinked or laid over sharp edges, walked on or exposed to chemicals. A power cable with damaged insulation can cause electric shock and fire.
Important Safety Instructions Air ventilation and high temperatures Prevent small items from getting into the interior of the device through the ventilation slots. Such objects may cause short circuits, which may cause fire. Install your TV only where there is proper ventilation, and ensure that there is at least 10 cm free space on the sides and 20 cm above the unit for air circulation. Excessive heat and obstruction of ventilation could lead to fire or early failure of some electric components.
Important Safety Instructions If you have a cardiac pacemaker, keep a distance of at least 22 cm from the TV. Radio waves may interfere with the operation of a pacemaker. Supervision - Do not let children play unsupervised close to the TV. It could tip over, be pushed off or pulled down from the stand surface and injure someone. Built-in wireless LAN - Do not allow a switched-on TV to run unattended. - Do not connect to wireless networks that you do not have the usage rights for.
Important Safety Instructions Cleaning and care swallowed. If swallowed by mistake, force the patient to vomit and visit the nearest hospital. CAUTION: Unplug the power cord prior to cleaning the TV. Clean the TV, the screen, and the remote control with a soft, moist, clean and color-natural cloth only. Do not use any chemicals. Modification Do not attempt to modify this product in any way. Unauthorized modification could void the warranty of this unit, cause electric shock and fires.
Contents Figures and illustrations in this manual are provided for reference only and may differ from actual product appearance. Parts of the software function changes with the system upgrade. Contents Accessories List..............................................................................................................1 Installing the Stand or Wall mount bracket .....................................................................2 TV Front............................................................
Installing the Stand or Wall mount bracket CAUTION Be sure to disconnect the AC power cord before installing a stand or wall mount brackets. The display on your TV is fragile. Make sure the TV screen is not scratched or damaged by hard objects or from pressure. After the installation is completed, make sure the TV is steady on a table or firmly attached to a wall mount, before removing all protective film, if any.
Installing the Stand or Wall mount bracket Installing the wall mount bracket Before mounting the TV, remove the TV stand if you have already attached it, and make sure the wall mount bracket supports the weight of your TV. CAUTION When mounting the TV on a wall, follow instructions provided with the wall mount bracket. If it is not correctly mounted, the TV may fall and cause property damage or personal injury. ≤15° Place spacers between the TV and bracket.
TV Front TV Front Remote sensor/Power indicator/Single button (Standby/Source) Item Description Remote sensor Receive remote signals from the remote control. Do not put anything near the sensor, as its function may be affected. Power indicator The light is red in standby mode. Press the single button when in standby mode, and the TV will be turned on. Press the single button to call up the menu.
TV Rear TV Rear USB 1 DC 5V 0.5A(MAX) ANT 2 DVB-S/S2 13/18V 0.5A ANT 1 DVB-T/T2/C COMMON INTERFACE AV IN R L VIDEO SERVICE HDMI 1 4K@60Hz AC INPUT LAN HDMI 2(eARC) 4K@60Hz HEADPHONE Not all A/V devices have the ability to connect to a TV. Please refer to the user’s manual of your A/V device for compatibility and connections procedure. Before connecting external equipment, remove the mains plug from the wall socket. Otherwise, it may cause electric shock.
Making Connections LAN (Wired setup) Connect your TV to your network by connecting the LAN port on the back of your TV to an external modem or router using a LAN (Ethernet/Cat 5) cable. See the illustration below. · It is recommended to use a modem or router that supports Dynamic Host Configuration Protocol (DHCP). Modems and routers that support DHCP automatically provide the IP address, subnet mask, gateway, and DNS, so you don’t have to enter them manually. Most home networks already have DHCP.
Making Connections Outdoor Antenna Cable ANT OUT or ANT 1 DVB-T/T2/C (not included) Antenna Cable (75Ω) VHF/UHF Antenna ANT ANT 2 DVB-S/S2 13/18V 0.
Making Connections 2 1 CAM CARD COMMON INTERFACE SMART CARD NOTES Before you insert/remove the CI+ module, ensure that the TV is switched off. Then insert the CI card into the CI+ module in accordance with the Service Provider's instructions. Do not repeatedly insert or remove the Common Access Module as this may damage the interface and cause a malfunction. You must obtain a CI+ module and card from the service provider of the channels you want to watch.
Remote Control 1 INPUT: Select input sources 1 2 2 POWER: Switch the TV on or into standby mode 3 Number button: Direct channel selection or numbers input 4 GUIDE: Display the Electronic Program Guide (DTV 3 mode) 5 CH.
Remote Control 1 POWER: Switch the TV on or into standby mode 1 2 2 INPUT: Select input sources 3 Number button: Direct channel selection or numbers input 4 GUIDE: Display the Electronic Program Guide (DTV 3 mode) 5 CH.
Remote Control Installing Batteries in the Remote Control 1. Slide the back cover to open the battery compartment of the remote control. 2. Insert two AAA size batteries. Make sure to match the (+) and ( - ) ends of the batteries with the (+) and ( - ) ends indicated in the battery compartment. 3. Close the battery compartment with the cover. NOTES Product image is only for reference, actual product may vary in appearance.
Remote Control Remote Control Operation Range 1. The remote control can work at a distance of up to 8 metres in front of the TV set. 2. The remote control angle: taking the remote sensor as an apex, 6 metres away, its controlled horizontal angle is within ±30°, while the vertical angle is within ±15°. 3. The operating distance may vary depending on the brightness of the room. Disposal of this unit Product should not be damaged, dismantled or thrown in municipal waste.
Turning the TV on for the First Time Turning the TV on for the First Time 1. Connect the mains cable to the mains socket after you have completed all the connections. 2. The first time you turn the TV on, it will go straight into the Installation Guide. 3. Press the [ / / < / > ] buttons to navigate the menu and change the settings. Press the [OK] button to confirm. Select your Language Select your desired language to be displayed on the menu. Press menu button to set up your TV for store mode.
Specifications Features, appearance and specifications are subject to change without notice. Item Dimension (W × H × D) Weight 50" Without Stand 43.8 × 25.4 × 3.1 inches (1112 × 645 × 79 mm) With Stand 43.8 × 28.0 × 10.4 inches (1112 × 711 × 263 mm) Without Stand 24.7 lbs (11.2 kg) With Stand 25.1 lbs (11.4 kg) Active Screen Size (Diagonal) 126 cm Screen resolution 3840 × 2160 Audio power 10W + 10W Operating mode power density 0.020 Watts/cm² Power consumption when turned off < 0.
Specifications HDMI Input RGB / 60Hz (640×480, 800×600, 1024×768) YUV / 60Hz (480i, 480p, 720p, 1080i, 1080p) YUV / 50Hz (576i, 576p, 720p, 1080i, 1080p) 3840×2160 / 24Hz, 3840×2160 / 25Hz, 3840×2160 / 30Hz, 3840×2160 / 50Hz, 3840×2160 / 60Hz EPREL Registration Information Model identifier Eprel registration number 50E76GQ 406632 50E77GQ 406635 50E78GQ 406643 50E79GQ 406644 50E76GQCH 406645 50E77GQCH 406646 50E79GQNE 406647 50E76GQTUK 406651 50E77GQTUK 406653 15
Other Information Recycling/Licenses WEEE (Waste Electronic Electric Equipment) European Directive 2012/19/EU This symbol on the product or on its packaging indicates that this product must not be disposed of with your household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling of waste electrical and electronic equipment.
