User guide

Part No. 4801-5338 Rev 01-10 Evolution 4000 64 of 86
PowerTrak
AUX
SWITCH
CONTROLLER AC IN
HOT
NEUT.
LOWER
GND.
HOT
OUT
CLOSE
IN
OPEN
IN
COM
UPPER
9.12 Connecting the PowerTrak to the Evolution 4000
NOTE: If curtain is setup to pull curtain up to open, then reverse wires connected to "OPEN" and "CLOSE"
terminals.
NOTE: Only 1 Power Trak can be connected to each Power Trak outlet. If Additional Power Traks are needed,
Then use of relay boxes is necessary to separate the load.
NOTE: All PowerTrak units will connect the same.
Inset A
Vent Connections
Inset B
PCB191 Relay Board
WARNING!
Keep High Voltage (Or AC)
Separate From Low Voltage
Wires!
COM
Open
COM
Close
Evolution 4000
Inset A
Apply Vent Label
to cover label.
Refer to Section 9.11.