User guide

Part No. 4801-5338 Rev 01-10 Evolution 4000 28 of 86
• High Static Pressure due to lack of inlet opening.
NOTE: Due to the nature of these errors, the control tunnel enable must be reset in order for the
control to re-enter tunnel. Be sure to check the cause if this is a reoccurring problem.
6.7 Program Set-Up
The Program Setup screen is used to select all of the Programming screens. Highlight an entry and press
the ENTER button. See the next section of this manual for a description of the programming screen.
(1) General Settings – Parameters that usually need to
be set when the system is installed. See Section 7.1.
(2) Network Status –See Section 0.
(3) Temperature Sensors –See Section 7.3.
(4) Feed Level Sensors - See Section 7.4.
(5) Ventilation Inlets - See Section 7.5.
(6) Natural Ventilation - See Section 7.6.
(7) Growout Curve - See Section 7.7.
(8) Tunnel Ventilation - See Section 7.8.
(9) On/Off Stages - Settings for Set up of stages. See
Section 7.9.
(10) Variable Stage Outputs - Set-up for variable
stages. See Section 7.10.
(11) Stage Properties – See Section 7.11.
(12) Setup Feed Clocks – See Section 7.12.
(13) Setup Light Clocks - This feature is added for
those applications that desire light control. See
Section 7.13.
(14) Seasonal Programs & Security – See Section
7.14.
(15) Diagnostics - See Section 7.15.
(16) SD Card Operations - See Section 7.16.
1. General Settings "
2. Network Status
3. Temperature Sensors
4. Feed Level Sensors
5. Ventilation Inlets
6. Natural Ventilation
7. Growout Curve
8. Tunnel Ventilation
9. On/Off Stages
10. Variable Stage Outputs
11. Stage Properties
12. Setup Feed Clocks
13. Setup Light Clocks
14. Seasonal Programs & Security
15. Diagnostics
16. SD Card Operations