User Manual

HIRED-HAND MFG., INC. • 1733 County Road 68 • Bremen, Alabama 35033 • Phone [phone] • Fax [phone]
Manual Part No. 4802-5084 rev 6-07 Page 2 of 4
PARTS LIST
TABLE A
INSTALLATION
The Base Bracket includes holes for mounting the assembly to a round or square colum n up to 4” Diameter with customer
supplied hardware. Refer to Figure 3 for Base Bracket hole sizes and spacing.
CAUTION
Do Not Use Lag Bolts To Secure The Wall Bracket To The Mounting Surface.
Lag Bolts May Turn Loose Over Time Due To Vibrations And Pressure.
FIGURE 3
1. Mount the Base Bracket with custom er supplied hardware. U-bolts or straight bolts can be used with the Base
Bracket. If straight bolts are used for mounting the bracket to a column, ensure the bolts are mounted completely thru
the column with washers on both sides of the column and nylon-insert lock-nuts for proper su pport. Ensure adequate
clearances are allowed in all directions for fan horizontal and tilt positioning.
DANGER
• Do Not Install Orifice Fan Within Range Of Human Or Animal Contact!
• The Post Mount Assembly Must Be Mounted To A Structurally Sound Column Or Mounting Surface!
Failure To Follow These Instructions May Result in Equipment Damage, Injury, Or Death!
!
!
Item #
Description Qty.
6403-4004 Base Bracket 1
6403-4003 Arm 1
6403-4000 Swivel Sleeve Bracket, Right 1
6403-4001 Swivel Sleeve Bracket, Left 1
1004-7001 Screw, ½-13 x 2” Hx Hd 2
1001-1454 Nut, Nylon-Insert, ½-13 2
1004-8006 Screw, ¼-20 x 1”, SS 2
Item #
Description Qty.
1001-0104 Nut, Nylon-Insert, ¼-20, SS 2
1004-2533 Bolt, ¼-20 x 1” 13
1001-1446 Nut, Nylon-Insert, ¼-20 13
1003-5010 Washer, Flat, ¼” ID x ¾” OD 24
1004-1424 Bolt, 3/8-16 x 1-1/4” 2
1001-1456 Nut, Hex, 3/8-16 2
Base Bracket