Owner manual

Part No. 4801-0062 rev 7-05
Super Saver Bunsen Jet Page 6 of 18
The Super-Saver Bunsen Jet radiant brooder uses a reliable hot surface ignition system to ignite the burner.
The Bunsen styled burner’s flame impinges on the surface of the cast ceramic element. The heat is then
transferred to the livestock in the form of radiant heat and convection heat.
All controls are located on the gas inlet side of the controls enclosure. There is only one control switch,
with an on and off position. Place the switch in the on position to start brooder, and place the switch in the
off position to shut the brooder down.
5. Use of equipment
This radiant brooder is designed to heat agricultural enclosures. The unit may be used in conjunction
with a thermostat or as part of an environmental control system with an electronic controller.
6. Assembly
6.1. Tools Required
½” Wrench Phillips Screwdriver
11/32” Nut Driver Gas Leak Testing Solution
Pipe Thread Sealing Compound Wire Pliers
6.2. Igniter Assembly
1. For igniter assembly, see Figure 1 in back of manual, then follow these steps.
2. Insert igniter [1] into igniter bracket [2] as shown.
3. Secure assembly with the 8-32 X 1/2” screw [3] and 8-32 nut [13] provided.
6.3. Burner Assembly
1. For burner assembly, see Figure 2 in back of manual, then follow these steps.
2. Place igniter assembly [6] onto burner mount plate [5]. Secure with three 8-32 X 1/2
screws [4] and 8/32 nuts [13] provided.
3. Take the flame sense probe [7] and one 8-32 X ½ screw, and run the metal end of the
ground probe from the bottom, through the hole shown in the burner mount plate.
4. Place the large hole in the ground probe over the metal end of the flame sense probe [7]
and secure the ground probe and flame sense probe to the burner mount plate with the
screw[4].
6.4. Support Ring Assembly
1. For support ring assembly, see Figure 3 in back of manual, then follow these steps.
2. Insert one suspension rod [9] through each of the openings in the outside of the support
ring [8]. The suspension rod will slide through the opening until the swaged portion
located on the middle section of the bracket is reached.
3. Rotate the bracket [9] until the swaged portion mates with the opening, insert the bracket
through the opening so that the opening is between the swages, then rotate the bracket so
that it is positioned with mounting pedestals pointing inwards toward the center of the
support ring [8], as in Figure 4.
6.5. Burner Unit Assembly
1. For burner unit assembly, see Figure 4 in back of manual, then follow these steps.
2. Attach the burner assembly [11] to the suspension rods [9] with the six 8-32 X 1/2”
screws [12] and 8-32 nuts [13] provided.
3. Place ceramic element [14] on top of the support ring.