Owner manual

Part No. 4801-0062 rev 7-05
Super Saver Bunsen Jet Page 15 of 18
11. Replacement Parts (120V & 240V models)
Ref. No. Part No. Description
1 3002-3000 IGNITER mini 120V BJ-32/42-HIS
7 1901-3061 FLAME SENSOR probe assembly BJ-32/42-HIS (120V model)
7 1901-3089 FLAME SENSOR probe assembly (240V model)
14 0015-0100 CERAMIC cast radiant BJ-32/42
21 6410-0105 Burner orifice assembly 0-2000 ft BJ-32-LP
21 6410-0106 Burner orifice assembly 0-2000 ft BJ-32-NG
21 6410-0108 Burner orifice assembly 0-2000 ft BJ-42-LP
21 6410-0109 Burner orifice assembly 0-2000 ft BJ-42-NG
25 0404-7554 Burner Heat Shield
Not Shown 3010-1883 FUSE 5 AMP ¼”X1-1/4” fast acting
Not Shown 1042-2693 FUSE_HOLDER shock safe
Not Shown 3004-0104 GAS_VALVE White Rodgers 120 VAC LP BJ-32/42-HIS
Not Shown 3004-0105 GAS_VALVE White Rodgers 120 VAC NG/LP BJ-32/42-HIS
Not Shown 6410-0115 Brooder HIS120V Module
Not Shown 3001-2862 SWITCH SPST toggle tabs
Wiring Diag. 3008-2858 Transformer 230V to 115V (240V model)
12. Troubleshooting Guide
Symptom Possible Cause Solution
Main burner will not
ignite.
Thermostat may not be set
properly.
Set thermostat to desired house
temperature.
The burner venturi may be
restricted.
Clean burner venturi to remove
obstruction.
Igniter may not reach into
the path from the burner.
Make sure the manifold gas pressure is set
to manufacturer’s recommended pressure.
If not, adjust to recommended pressure.
Faulty gas valve. Replace gas valve.
Main burner will
flashback.
Gas pressure is set
incorrectly.
Adjust manifold gas pressure to
manufacturer’s recommended pressure.
The orifice may be
misaligned.
Adjust orifice so that it is positioned
perfectly vertical.
Igniter does not glow.
Igniter may be
disconnected.
Check that wires are connected both at the
ends of the white wires, and at the control
enclosure terminal block
Thermostat preventing
operation.
Make sure that your thermostat is set to
allow the brooder to operate at the present
temperature.
Igniter will glow, but
gas valve will not
engage.
Low gas pressure at gas
valve.
Check gas supply from line to gas valve to
be sure that all valves are open, and that
the regulator is functioning properly.
Clogged gas orifice. Check that nothing obstructs the flow of
gas from the orifice.
Burner is plugged. Check that the burner is clear and free
from obstructions.
Brooder will light,
Low gas supply. Check gas supply.
but then go out.
Thermostat too close to
brooder
Move thermostat farther away from
brooder to prevent rapid heating of