User's Manual

2
Your Guide to Solo
Note: References to DAB/DAB+ apply only to models outside North America.
Front
1. Power/Volume: Push in briefly to turn Solo on or off. Rotate to adjust the volume.
2. Menu: Press and hold to call up the main Menu. Rotate to navigate the Menu and push in briefly to select.
In DAB mode, rotate to call up the DAB station list and push in briefly to select a station.
In FM mode, rotate to manually tune stations or push in briefly to auto seek to the next strongest FM station.
When artwork is displayed, such as an album cover or station logo, push in briefly to expand the image to fill
the display. Push in briefly again to return to the standard display.
When the alarm activates, push in briefly to snooze. Push in briefly again during snooze to reset the snooze
timer.
3. Source: Rotate to call up and navigate the source menu. Push in briefly to select the source. When in the
Menu, push in briefly to go back one page with each push.
4. Presets: Press and hold to save a tuned station or a source. Push in briefly to recall the saved station or
source. The presets are independent and are not restricted to whichever source is playing. The presets will
also turn Solo on from standby if a station or source has been saved to that preset.
5. NFC (Top of cabinet):
If your Android smartphone has NFC, make sure it is switched on in your device and be sure the display on
your device is unlocked. Change Solo’s source to Bluetooth. Touch the NFC area of your smartphone to the
NFC logo on the top of Solo’s cabinet. You may need to adjust your smartphone’s position around the
cabinet’s NFC logo until it locates the signal. If your smartphone is in a case, the case might reduce the NFC
signal. Once NFC is established, follow the instructions displayed on your smartphone to establish the
Bluetooth connection. Touch your smartphone to the cabinet’s NFC logo again to disconnect from Bluetooth.
If your device does not support NFC, see the section marked “Bluetooth”.