User Manual

17
────────────────────────────────────────────────────
2.4 Connection of the Input Product
────────────────────────────────────────────────────
Adapted clamp's
plug
Instrument's sensor connector
Conversion cable plug
Conversion cable connector
Groove on the 3273 CLAMP ON
PROBE's termination connector
Conversion cable plug
Pro
j
ection on the instrument connecto
r
Sensor connector
on the instrument
Connecting the 9318 CONVERSION CABLE
1. Align the groove on the conversion cable plug with
the sensor connector on the 8951 and push inward
until the connector locks into place.
2. Align the groove on the conversion cable connector
with the adapted clamp on sensor plug and push
inward until the connector locks into place.
3. To unplug the cables, slide the lock ring on each
plug outward to unlock it, then pull out the plug.
Connecting the 3273, 3273-50, 3274, 3275,
3276 CLAMP ON PROBE
1. Align the groove on the 3273, 3273-50, 3274,
3275, 3276 CLAMP ON PROBE's termination
connector with the pin on the BNC connector on
the 8951, then slide the termination connector over
the BNC connector and turn to lock it in place.
2. Align the groove on the 3273, 3273-50, 3274,
3275, 3276 cable plug with the power connector on
the 8951.