User Manual

200
────────────────────────────────────────────────────
11.3 PPP connection
────────────────────────────────────────────────────
Outbound settings
If LAN is set as the save location for the Auto Save and Save buttons, when
files are saved, the PC is dialed from the recorder and the data saved in the
specified location.
Two locations (A and B) can be registered as the dial destination, and
dialing is performed according to the settings made in Pattern on the PPP
settings screen.
However, when data is being sent from the PC to the recorder, dial
operations are not necessary because the inbound connection is used instead.
"Outbound" user name and password
Sets a user name and password used for authentication when connecting to
a PC. Passwords are displayed as "********".
User names and passwords are common to both the A and B dial
destinations.
Dial A/B telephone numbers
Sets the telephone number for the connection point. Two locations (A and
B) can be specified. When only specifying one location, set A.
DNS specification and IP addresses for Dial A/B
When using the DNS connection point, select this setting and set the IP
address for DNS. If you want the IP address to be automatically acquired
upon connection, set Automatic Acquisition as the Priority Setting.
Dial A/B data collection server
Specifies the PC on which the 9333 data collection server is operating.
Connection point: Specifies the device for connection.
IP Address: Specifies the server using IP.
Host Name: Specifies the server using a host name (DNS is required).
When IP Address is selected, an IP address is set in the next column
below. When Host Name is selected, a host name is set in the next
column below.
Save backup
When files are set to be saved automatically (when LAN is selected as the
Save Media), a backup media is set for the instrument according to the
following connection patterns.
Save pattern
Specifies a pattern for connection when files are saved automatically.
When an inbound connection is made, the pattern applies to the inbound
connection only.
A --> B --> backup: Changes the save destination in order until
successful.
(A --> B) + backup: Tries A --> B in order, and makes a backup of files
regardless of whether the save was successful.
(A + B) --> backup: Saves to both A and B save locations, and makes a
backup of files if both attempts to save to A and B fail.
A + B + backup: Saves to all three locations.