User Manual

190
────────────────────────────────────────────────────
10.6 Printing Procedure
────────────────────────────────────────────────────
10.6.5 Screen Hard Copy
NOTE
10.6.6 List Print
NOTE
10.6.7 Report Print
The display contents of the all screens can be printed out as is.
Procedure
Screen: All
1. Display the desired screen.
2. Press the
COPY
key.
Even if the gauge is set to the List & Gauge function, the gauge is not
printed out in the screen copy mode. The screen hard copy function is not
available during measurement.
The settings for the various functions made with the Status screen, Channel
screen etc. can be printed out in list format.
Procedure
Screen: Excluding Waveform display
Press the
PRINT
key on the screen excluding Waveform display.
The list to be printed contains the setup conditions for the acquired
waveforms. Even if the settings are changed following wave acquisition, the
contents of the list remain unchanged.
Prints the waveform (in the range displayed on the Waveform display
screen), upper and lower values, and analog channel settings.
If the A and B cursors are displayed on the screen, they are also printed.
When "COMMENT"or"SET & COM" is set, the comments are also printed
(see Section 5.4).
Procedure
Screen: Waveform display
1. Display the Waveform display screen.
2. Press the
FEED
key and
COPY
key simultaneously.
(Press and hold the
FEED
key and then press the
COPY
key.)