User Manual

159
────────────────────────────────────────────────────
8.1 View Function (VIEW key)
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
8.1.2 Block Display
Function
display
Meaning
:
Shifts the destination to the left.
:
Shifts the destination to the right.
:
Executes the dislocation.
:
Toggles block display.
NOTE
When memory segmentation is being used, the memory block status is
shown. Any block in which an input signal is recorded can be called up on
the display.
Procedure
Screen: Waveform display
1. Press the
F7
(
SEARCH
) key on the Waveform
display screen.
2. The position is displayed.
3. Using the function key to select
Block Display
.
4. When the number of divisions is 31 or over,
change the bar graph using the up and down
cursor keys.
5. Use the function keys to move the " "mark
and specify the memory block you wish to
display.
6. Press the
F4
(
MOVE
) function key.
While the view function is active, the flashing cursor is not displayed and
the settings cannot be changed.
The memory segmentation function can be used in memory function.
When the memory is not split, you can refer to up to 16 blocks of past
waveforms by their recording lengths.
To exit from the view function, press the
ESC
key.