User Manual

158
────────────────────────────────────────────────────
8.1 View Function (VIEW key)
────────────────────────────────────────────────────
8.1.1 Position Display
TAB
Displayed part (30 divisions)
Trigger position A cursor B cursor
Time axis magnification ratio: x 1
Time axis magnification ratio: x 2
Time axis magnification ratio: x 1/2
Displayed part
Displayed part
Trigger time
Time from trigger point (MEM)
Time from starting record (Recorder)
Function
display
Meaning
:
Shifts the destination to the left.
:
Shifts the destination to the right.
:
Executes the dislocation.
:
Toggles block display.
NOTE
8.1 View Function (VIEW key)
Indicates the position of the currently displayed waveform within the entire
recording length. The trigger time, trigger position and A/B cursor position
are displayed when using the vertical or trace cursors.
When the recording length is 200 divisions:
Procedure
Screen: Waveform display
1. Press the
F7
(
SEARCH
) key on the Waveform
display screen. The position is displayed at lower
of the screen.
2. Press the
F6
(
VIEW
)key.
3. Use the function keys to move the ( )mark
to the desired point with function key.
Slide the bar graph cursor to select from 0, 25,
50, 75, and 100% of full recording length, trigger
point, and A and B cursors.
4. Press the
F4
(
MOVE
) function key. The high-
speed shift is carried out and the display position
changes.
While the view function is active, the flashing cursor is not displayed and
the settings cannot be changed.
Even during measurement, the position of the waveform can be displayed by
pressing the
F7
(
SEARCH
)key.
When the recording length is set to "CONT." on the recorder and at least
20000 divisions (50000 divisions for 128 M words, 200000 divisions for
512 M words) are recorded, the time displayed does not represent the value
counted from the trigger point.
To exit from the view function, press the
ESC
key.