User Manual

149
────────────────────────────────────────────────────
7.2 Waveform Calculation (MEM)
────────────────────────────────────────────────────
NOTE
7.2.2 Defining the Processing Equation
Function
display
Meaning
:
Enter equation
:
Delete equation
:
Copy equation
Function
display
Meaning
:
Enter the item into selected equation.
:
Move the equation cursor right.
:
Move the equation cursor left.
:
Back space
:
Delete character under cursor in equation.
:
Terminate equation input.
If the cursors are overlayed so that they form a single cursor, that point only
is calculated.
You cannot use horizontal line cursors to specify an area for calculation.
If cursor A only is used, calculations are applied to the area from cursor A
to the end of the measurement data.
Sixteen processing equations (Z1 - Z8) can be defined.
Procedure
Screen: WAVE CALC (STATUS)
(1) Making the processing equation
1. Press the
STATUS
key to display the waveform
calculation screen.
2. Move the flashing cursor to
Equation
.
3. Move the cursor to the desired item with the
JOG/SHUTTLE
control or the cursor key.
Use the function key to move the cursor.
4. When the equations have been input, select
EXIT
function key. If there are any syntax errors in
the equations (incomplete bracketing, missing
"*", more than four MOV, SLI, DIF, DIF2, INT,
INT2 operators, etc.), a "?" is displayed, and the
cursor rests on the error, so that the problem can
be corrected. When there are no syntax errors, a
"=" is displayed.
5. Make settings for Z2 to Z8 as for Z1.