User Manual

113
────────────────────────────────────────────────────
5.6 Setting the Waveform Display Screen
────────────────────────────────────────────────────
5.6.3 Setting the Vernier Function
Function
display
Meaning
:
Cancel the vernier function (restores the
waveform to its original size)
:
Compresses the waveform.
:
Magnifies the waveform.
NOTE
With the vernier function, input voltage can be minutely adjusted to the
desired value. When recording various physical quantities using noise,
temperature, and acceleration sensors, this vernier function allows you to
adjust amplitudes to assist with calibration. For example, use the vernier
function when you want to convert an input voltage of 1.2 V to 1.0 V and
display the converted value.
Procedure
1. Press the
DISP
key to display the Waveform
display screen.
2. Press the
F9
(
CH.SET
) key and move the flashing
cursor to the channel to be set shown in the
figure on the left.
3. Use the function key to select the vernier
function.
is observed in its expanded state while is
observed compressed. The adjustable range is 50
to 200% of the original waveform.
The vernier function is not applicable to a waveform after waveform
processing.
The ratio of the waveform's enlargement or compression is not displayed.
The vernier function ON/OFF setting can be checked after the
F9
(
CH.SET
)
key is pressed to display each channel setting on the screen. This setting
cannot be checked using the printout or list print function.