Quick Start Guide

7
────────────────────────────────────────────────────
Display Screen and Setting Screen
────────────────────────────────────────────────────
Channel screen
The channel screen can be displayed by pressing the
CHAN
key located on the left side of the
unit. This screen is used to set units (analog input) and to enter logic input, display the setting s
for each channel, and to enter scaling settings, comments, and other detail settings.
The above screen shows the analog-setting list page. Press the Page Switch key (
F3
function
key) to change the display to pages for logic input setting, X-Y setting, and details (options)
setting. The following describes each of these pages.
Page change key
List
Indicates the channel. Settings can be copied between channels.
Indicates the unit type.
Used to select waveform display ON/OFF.
Used to select waveform graph ON/OFF.
This item is enabled when the display shows multiple screens.
Used to select the measurem ent mode. (voltage, current,
temperature, etc. )
Used to select the vertical axis (voltage axis) range.
Used to select the input coupling setting. (AC, DC, GND)
Used to select the low path filter ON/OFF.
Used to select vertical axis (voltage axis) zoom.
Used to set the zero position . This allows selection of the zero-
level setting point in the screen.
Used to select variable ON/OFF. The position and size of the
displayed waveform can be changed.
Indicates the voltage value per DIV (grid).
This setting can be entered when Variable is ON.
Indicates the upper- and lower-limit values of the display screen.
This setting can be entered when Variable is ON.
Indicates the upper- and lower-limit values within the selected
measurement range. Measurement cannot exceed these levels.
Indicates the measurement unit of the vertical axis.
Logic page
Selection of logic
waveform display
ON/OFF, display position,
display width, and analog
input waveform resolution
display ON/OFF (For
details, refer to section
6.3.10 of the Quick Start
Manual.)
Page
F3
XY page
This screen is enabled
when the display mode
(setting item in the status
screen) is set to "XY
screen."
XY waveform setting
(ON/OFF) and channel
selection for the X- and
Y-axes
Page
F3