Quick Start Guide

22
────────────────────────────────────────────────────
Measurement Method
────────────────────────────────────────────────────
4. Details
1. Setting the t ime axis and recording length
For measurement of the output of the
acceleration sensor, follow the setting procedure
described below.
Press the
STATUS
key to display the status
screen.
Move the flashing cursor to "Time/Div" or
"Shot."
To capture a waveform for a period of one
second at a 100 k sampling rate, use the
function keys to set the "Time/Div" to "
1ms/DIV
"
and the "Shot" to "
1000 DIV
."
3. Setup
Display Setting item Setting
Status screen Time axis (Time/Div) 1ms/DIV
Recording length (Shot) 1000DIV
Channel screen Range CH1 200 mV
Scaling CH1 In decimals (ENG)
Setting method (Scaling Kind) CH1 Set with 2 points (POINT)
Input P1 - Scale P1 CH1 [2.000] - [5.000]
Input P2 - Scale P2 CH1 [-2.000] - [-5.000]
Unit CH1 G
Trigger screen Trigger mode Single
Pre-trigger 5%
Kind CH1 Level
Parameter CH1 Level: 200 mV
Slope:
Display the status screen.
Move to "Time/Div" or "Shot."
Press the function ke y corresponding to the setting
displayed in the screen.
Status screen
Set to 1 ms/DIV.
Set to 1000 DIV.