Quick Start Guide

10
────────────────────────────────────────────────────
Display Screen and Setting Screen
────────────────────────────────────────────────────
Status screen
The s tatus screen can be displayed by pressing the
STATUS
key located on the left side of the
unit. This screen is used to enter basic waveform data-acquisition settings, mem ory allocation
settings, and calculation settings.
In addition to the basic setting page shown above, the status screen includes the three pages
specified below. To change pages, press the menu key (
F1 F2
function keys) or
CHAN
key.
Regarding the setting method, refer to the Instruction Manual provided with the product.
STATUS
Used to set the time axis (horizontal axis). The sampling speed
changes automatically.
Used to set recording length. The recording time changes
automatically.
The recording length can be set in increments of 1 DIV.
Used to set the number of screens for split display
The display mode can be selected from among four types: 1-
screen, 2-screen, 4-screen, 8-screen, and X-Y1 screen.
Whe n roll mode is set, the screen changes (scrolls) in sync with
waveform recording at time axis slower than 10 ms/DIV.
The waveform judgment function can be
used when this is turned ON. For details,
refer to Chapter 9 "W aveform Evaluation
Function" in the Instruction Manual.
Whe n "Superimp osition" is turned ON, a new waveform is
displayed over the previous waveform if the trigger mode is set
to "Repeat" or "Auto."
When "Averaging" is turned ON, waveform data is obtained the
set number of ti mes, and the average of all data is displayed.
The "Channel in use" item is used to set the number of channels
for measurem ent-data memory allocation.
MEMORY DIV (Chapter 6 "Memory
Segmentation Function" in the Instruction Manual)
MEASUREMENT (Chapter 7: 7.1
"Numerical Calculation" in the Instruction Manual)
WAVE CULC (Chapter 7: 7.2
"Waveform Calculation" in the Instruction Manual)