User Manual

────────────────────────────────────────────────────

4.3 STATUS Settings (MEM)

────────────────────────────────────────────────────

.3.12 Setting the Averaging Function

Screen: STATUS

Press the STATUS key to call up the

STATUS1 screen.

Move the flashing cursor to the averaging

item, as shown in the figure on the left.

Use the JOG control or the function keys

to set the averaging count.

：Move the cursor up in the selectio

window.

：Move the cursor down in the

selection window.

Selection

Method

After starting the measurement, the

averaging count and the current waveform

data count are shown on the screen.

NOTE

・The averaging function allows capturing several instances of a waveform

and determining the average.

・This makes it possible to eliminate noise and irregular signal components.

・The higher the number of averaging instances, the more effectively will

noise be suppressed.

・When the averaging function is used, logic waveform is not displayed.

・When the memory segmentation function is used, averaging is not available.

・Averaging and waveform processing cannot be carried out simultaneously.

・The averaged waveform becomes available for waveform processing when the

averaging setting is turned OFF following measurement.

・When the averaging function is used, the maximum recording length is

reduced to 25% of the normal value.