User Manual

────────────────────────────────────────────────────

4.3 STATUS Settings (MEM)

────────────────────────────────────────────────────

Move the flashing cursor to type, and selec

the format.

：Data are stored as binary data.

：Data are stored as text data.

Data stored in the text format is

not readable by the 8826.

Selection

When the data format to be saved is set to

text data, the intermittent setting item is

displayed. Use the function keys or Jog

control to make a setting.

：Move the cursor up in the selection

window.

：Move the cursor down in the

selection window.

Selection

Set the file name. For the input method,

refer to Section 9.8.4.

When using auto-save, a number is

appended to the name you specify as the file

name. This then becomes the file name. If

you start procedures before specifying a file

name, AUTO is automatically enabled.

・ Do not use the characters and symbols below

in a file name. A file containing any of these

characters/symbols in its file name cannot be

processed under Windows 2000 or XP. Half-

size symbols: +, =, [,]

NOTE

・When auto-save is enabled, the storage channel cannot be selected. Data for the

channel for which the waveform is displayed is saved.

・For details on auto saving file name, refer to Section 14.7.

・When both auto-print and auto-save are enabled, auto-save usually takes

precedence. However, if roll mode is enabled, auto-print will execute first.

・For details on connected SCSI device, refer to Section 14.4.

・When cursor A and B are enabled, partial saving is executed.

・During automatic storage, if the STOP keyispressedtwicetointerrupt

measurement, waveforms taken prior to the interruption are stored

automatically.

・The directory and the number of files that can be stored in the directory are

limited. For details, see Section 14.7.

・When "COMMUNI" (communications) is selected as Media, Storage Method and

Type are not displayed.