User Manual

────────────────────────────────────────────────────

4.2 Operation Sequence (MEM)

────────────────────────────────────────────────────

測定を開始します

・Press the START key and the LED lights.

・When the trigger conditions are met, measurement start.

・Press the STOP key and the LED goes out after measurement has

finished.

Printout the measurement data

Save the measurement data

Wave scrolling

See Section →11.1.

Using the A/B cursor

Zoom function

See Chapter →13.

See Chapter →14.

See Section →11.2.

Starts Measurement

Setting the magnification/compression ratio

See Section →11.3.

Sequential Save Function

Multi-Block Function

・See Chapter →12.

Setting the SYSTEM Scree

Operating the DISPLAY Scree

・Set the trigger source, trigger types and conditions, the pre-

trigger, etc.

See Chapter 10.

・Set the waveform display color for each channel,

measurement range, input coupling, zero position, and filter.

See Chapter 9.

Setting the CHANNEL Scree

Setting the TRIGGER Scree

Setting the SYSTEM Scree

Operating the DISPLAY Scree

Printouts and Saves the dat

Advanced function

Printouts and Saves the dat

See Section →11.4.

Memory segmentation

Advanced function

・See Chapter 15.

Waveform operation Function

・See Chapter 16.

Waveform parameter calculatio

Calculatiing Waveform Dat