User Manual

42
────────────────────────────────────────────────────
4.2 Operation Sequence (MEM)
────────────────────────────────────────────────────
測定の準備を行います
Installation of the Unit
Turn on the power
Connect the inputs
Select the function
Time axis range
・Select the memory recorder function.
Recording length
・Determine the speed with which the input signal
waveform is captured.
Select the format
Print mode
Set the roll mode.
Set auto print function.
Set auto save function.
・See Chapter 2.
Preparation
・Press the STATUS key to call up the
STATUS screen.
・See Section 4.3.
Overlay function
Display size
Interpolation (dot-line)
Averaging
・Select the average count.
Waveform evaluation
Setting the items
Setting the stop mode
See Section 16.3.2.
・Determine the length of the data sample for a single
measurement.
・Select the format type for the waveform display screen.
・Select the format, waveform, or numerical value should
be used to output measured data and calculation results.
・Select whether or not to display the waveform at the
same time as it is captured.
・Select whether or not to print out the waveform
automatically after it is captured.
・Select whether or not to save the waveform automatically
after it is captured.
・Select the display size normal or wide.
・Interpolation can be set when set the X-Y graph format.
Setting the STATUS1 scree
n
Setting the STATUS1 scree
n
See Section 4.3.1.
See Section 4.3.2.
See Section 4.3.3.
See Section 4.3.4.
See Section 4.3.5.
See Section 4.3.6.
See Section 4.3.7.
See Section 4.3.8.
See Section 4.3.9.
See Section 4.3.10.
See Section 4.3.11.
See Section 4.3.12.
4
.2 Operation Sequence (MEM)