User Manual

35
────────────────────────────────────────────────────
3.2 Measurement Start and Stop
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
1
0
1
1
1
2
1
3
1
4
A
3
.1.5 Basic Input Operation
Set the basic settings for analog channels. See Chapter 9.
t
o
CH&NUM key Sets channels or inputs numerical values
・Channel parameters can be directly input
using the POSITION and the RANGE
keys.
・In numerical-value input, these keys are
used as numeric keys.
POSITION key Determines the zero position of the channe
l
set using the CH&NUM keys.
In numerical-value input, "-" and "+" can be
input.
RANGE key Determines the measurement range for the
channel set using the CH&NUM keys.
In numerical-value input, "."(decimal point)
and "E" can be input.
AUTO key Serves to automatically set the time axis
range, measurement range and zero
position for the input waveform. (only in the
memory recorder function) See section 4.6.
TIME/DIV key Serves to set the input signal capture spee
d
(how many seconds, minutes, hours for 1
DIV on the time axis).
START key Press the START key to initiate measurement or set the
unit to trigger standby.
STOP key Press the STOP key during measurement and trigger
waiting to stop the measurement.
LED: light during
measuremen
t
NOTE
3
.2 Measurement Start and Stop
The measurement start/stop operation is separately determined by each
measurement function. For details, see "Starting and Stopping
Measurement," which explains each measurement function.