User Manual
492
────────────────────────────────────────────────────
21.1 Error Messages
────────────────────────────────────────────────────
W
ARNING 60：Insert MO disk. ・No disk is present in the MO disk drive. Insert one.
W
ARNING 70：Insert Floppy disk． ・No disk is present in the floppy disk drive. Insert one.
W
ARNING 71：Cannot load
（not 8826 data）
・Data cannot be loaded, because it is not a set of data
created by the 8826.
W
ARNING 72：Illegal format． ・The floppy disk is not a correctly formatted MS-DOS
disk, or is a 2DD, 640 KB format disk.
W
ARNING 73：Write Protected． ・The floppy disk is write-protected. Change the write-
protect setting or use a different disk.
W
ARNING 74：Disk full． ・There is insufficient space remaining on the floppy disk
.
W
ARNING 75：File is read only． ・File cannot be written or deleted, because it is read-
only.
W
ARNING 76：General failure． ・Access to disk is not possible because of some low-level
error, such as in formatting or file saving.
W
ARNING 80：Insert PC card. ・No card is present in the PC card slot. Insert one.
W
ARNING 90：File already exists. ・Another file of the same name exists. Saving cannot be
performed.
W
ARNING 91：Directory full. ・Since only a limited number of files (including directory
)
can be created in the root directory.
W
ARNING 92：Directory not empty. ・The directory is not empty.
W
ARNING 93：Disk full. ・Little capacity is available.
W
ARNING 94：Path name error. ・Up to 127 characters can be used for a path name.
W
ARNING 95：Empty directory name. ・Name the directory.
W
ARNING 96：Directory already exists. ・Another directory of the same name exists. Saving
cannot be performed.
W
ARNING 97：2DD type FD. ・2DD-type FD. Select the suitable format.
W
ARNING 98：2HD type FD. ・2HD-type FD. Select the suitable format.
W
ARNING 99：Conditions for OVERWRITE
are not satisfied.
・Match the unit condition and file data condition
(function and time-axis).
W
ARNING 201：Set printer paper. ・Printer paper has run out. Reload.
W
ARNING 202：Set printer lever ・The head up/down lever has been left in the up position
.
W
ARNING 205：Invalid（START） ・The key pressed is not valid, because measurement
operation is in progress.
W
ARNING 207：AUTO RANGE failure． ・The auto ranging function has failed. Check the input
signal.
W
ARNING 208：Cannot SAVE.
(Write Protected)
・Remove the write-protect.
W
ARNING 209：Cannot SAVE. (Disk Full) ・Little capacity is available.
W
ARNING 213：Invalid
（MEASUREMENT）
・Pressed key is invalid, because parameter processing is
ON.
W
ARNING 214：Invalid. (Pre Trigger) ・Additional recording set on, therefore pre-trigger can
not be set.
W
ARNING 215：Cannot set -95%. ・The pre-trigger cannot be set "-95%" at a recording
length of 160000 DIV.
■ Warning Messages
・The "WARNING" indication is displayed on the bottom line of the screen, followed
by the message, but disappears after a few seconds.
・Warning messages also disappear if any key is pressed.
・If the "beep sound" item on the system screen is set to ON, then the beeper
sounds once only when the message is displayed.
■ Warning Message and explanation