User Manual

436
────────────────────────────────────────────────────
16.3 Waveform GO/NG Evaluation
────────────────────────────────────────────────────
1
6.3.4 Creating the Evaluation Area
Screen: STATUS1 (MEM
)
: STATUS2 (FFT)
Move the flashing cursor to the comparison
item. Press the
F5 [ Edit ].
Use these commands to create the
evaluation area.
When the area has been stored in memory
,
it can be used for waveform evaluation.
Press the F4 [ end ] function key to
terminate the editor.
Serves to store the created area in
memory.
Save the evaluation area through the file
screen, if necessary. See Section 14.7.
Method
Method
Fill in a closed area
Clear screen
Parallel shift
Clear area
Draw a straight line
Undo immediately preceding
command
Erase Store area in memory
Import waveform into editor Quit editor
Display filled-in area in revers
e
NOTE
・The graphics editor serves to create the waveform evaluation area.
・The area is created by drawing it on screen.
Editor commands
When the editor is active, the following commands are assigned to the function
keys.
The evaluation area is created on the wide screen (single screen: 25 x 24
divisions, X-Y screen: 24 x 24 divisions). When the screen size is normal
during evaluation of waveforms, the out-of-range area is not evaluated (MEM).