User Manual

433
────────────────────────────────────────────────────
16.3 Waveform GO/NG Evaluation
────────────────────────────────────────────────────
Screen: STATUS1 (MEM
)
: STATUS2 (FFT)
Press the STATUS key to call the
STATUS1 screen (MEM) or STATUS2
screen (FFT).
Move the flashing cursor to the position
shown in the figure on the left.
Use the function key to select the Edit.
Make the new evaluation area.
See Section 16.3.4.
Store the new evaluation area in the
internal memory.
After setting the parameters for
"comparison" and "stop mode," press the
DISP key to make the display screen
appear, and then press the START key to
initiate measurement.
Save the evaluation area on the FILE
screen if it is necessary. See Section 14.7.
Method
Method
NOTE
Creating a new evaluation area
Only one waveform evaluation area is saved in the internal memory. For
example, when the memory recorder function is changed to the FFT function
and the waveform evaluation area of the FFT is saved, the waveform
evaluation area created using the memory recorder function is erased.