User Manual

426
────────────────────────────────────────────────────
16.2 Calculating Waveform Data
────────────────────────────────────────────────────
1
6.2.5 Setting the Display Scale and Floating Decimal Point
Screen: STATUS4 (MEM
)
Press the STATUS key to call up the
STATUS4 screen.
Move the flashing cursor to the position
shown in the figure on the left.
Press the F1 [ SETTINGS ] key.
：Set the scale and floating decimal
point.
Selection
Selection
Method
Method
Move the flashing cursor to the position
shown in the figure on the left.
Make the setting with the function keys.
：Set display scale automatically.
Selection
Selection
：Set display scale manually.
If MOV or SLI was used, the floating
decimal point must be specified.
Move the cursor to the various digits and
make the setting with the function keys,
the JOG control or the CH&NUM key.
For MOV (moving average): 1 to 4000
For SLI (parallel displacement): -4000 to
+4000
：End.
Selection
Selection
：Value up.
：Value down.
：End.
・Display scale can be set automatically or manually.
・The channel selected for recording is automatically set to variable display. For
details on variable function, refer to Section 9.6.1.