User Manual

425

────────────────────────────────────────────────────

16.2 Calculating Waveform Data

────────────────────────────────────────────────────

6.2.4 Setting the Channel for Recording Processing Results

Screen: STATUS4 (MEM

)

Move the flashing cursor to one of the Z1 -

Z16 items.

Move the flashing cursor to the position

shown in the figure on the left.

Use the function keys or the JOG control

to specify the number of the equation to be

copied.

：Increase channel number.

Selection

Method

：Decrease channel number.

Equations not to be used should be set to

NONE (calculation result is not recorded).

NOTE

・The calculation result of equations Z1 - Z16 can be recorded and displayed in a

specified channel.

・Processing results can be recorded also in channels where no input unit is

installed (but the range of the "number of channels in use" setting cannot be

exceeded).

・If the same channel is selected as source in the equation and as target for

recording, the waveform data in the source channel are overwritten by the

equation calculation result.

・In the following cases, the calculation result is displayed with in the same

color set as the channel number for the first processing run:

If results are recorded in a channel where no input unit is installed.

If the display color for the channel selected for recording is set to OFF.

When wishing to change the display color set, perform calculation once and

then use the CHANNEL1 screen or DISPLAY screen to make the setting.

・The channel selected for recording is automatically set to variable display.