User Manual

19
────────────────────────────────────────────────────
2.4 Connection of the Input Unit
────────────────────────────────────────────────────
Unit’s BNC connecto
r
3273,3273-50
*1
connecto
r
Unit’s senso
r
connector
Conversio
n
cable plug
(2) Connecting to 9319 CONVERSION CABLE
The MEMORY HiCORDER and the equipment being measured are
powered off before making connections.
Align the groove on the 3273 or 3273-50
*1
CLAMP ON PROBE’s
termination connector with the pin on the BNC connector on the F/V
unit, then slide the termination connector over the BNC connector and
turn to lock it in place.
Align the groove on the conversion cable plug with the sensor connector
on the F/V unit and push inward until the connector locks into place.
To unplug the cables, Unlock the conversion cable connector and the
power plug on the 3273 or 3273-50
*1
before unplugging the cable.
Slide the lock ring on each plug outward to unlock it, then pull out the
plug.
When disconnecting the connector and the plug, hold the connector or
the plug, and pull carefully. Pulling on the cable instead of the
connector or the plug may damage the connector and cable.
*1 : When using the Model 3273-50 with the 8940, bear in mind that the
maximum input of the 3273-50 is 15 Arms.