User Manual

414
────────────────────────────────────────────────────
16.1 Waveform Parameter Calculation
────────────────────────────────────────────────────
1
6.1.2 Making Settings for Waveform Parameter Evaluation
Lower limit valu
e
Upper limit valu
e
GO resultNG result NG result
Screen: STATUS3 (MEM
)
Make the settings for waveform parameter
calculation.
Move the flashing cursor to the COMP item
.
And use the function key to select.
Method
Method
Selection
Selection
：Disable evaluation function.
：Return NG if result is outside
specified range.
Set the upper and lower limits.
The setting range is -9.9999E+29 to
+9.9999E+29 (exponent: -29 to +29).
Move the flashing cursor to the various
digits and make the setting with the
function keys, the JOG control or the
CH&NUM key.
The upper limits must not be smaller
than the lower limits, or the lower limits
must not be larger than the upper limits.
Use the function key to select the
TEN-KEY, the CH&NUM key can be
entered numerical value. For details, refe
r
to Section 9.6.1.
resul
t
NG channel marked with an "
*
"
・Depending on the results of the waveform parameter calculation, a GO
(pass) or NG (fail) result is returned.
・Evaluation criteria can be set independently for each of the calculation sets
No. 1 - No. 4.