User Manual

18
────────────────────────────────────────────────────
2.4 Connection of the Input Unit
────────────────────────────────────────────────────
Adapted clamp’s plu
g
Unit’s sensor connecto
r
Conversion cable plu
g
Conversion cable connector
(1) Connecting to 9318 CONVERSION CABLE
The MEMORY HiCORDER and the equipment being measured are
powered off before making connections.
Align the groove on the conversion cable plug with the sensor connector
on the F/V unit and push inward until the connector locks into place.
Align the groove on the conversion cable connector with the adapted
clamp on sensor plug and push inward until the connector locks into
place.
To unplug the cables, slide the lock ring on each plug outward to unlock
it, then pull out the plug.
When disconnecting the connector and the plug, hold the connector or
the plug, and pull carefully. Pulling on the cable instead of the
connector or the plug may damage the connector and cable.