User Manual

413
────────────────────────────────────────────────────
16.1 Waveform Parameter Calculation
────────────────────────────────────────────────────
16
17
18
19
5
6
7
8
9
1
0
1
1
1
2
1
3
1
4
A
Screen: STATUS3 (MEM
)
Move the flashing cursor to the position
shown in the figure on the left.
Use the function keys to make the
selection.
Up to four parameter calculations
(No. 1 - 4) can be set simultaneously.
Method
Method
Disable calculation Time to maximum value
Rise time
Average value
Minimum value
Fall time
RMS value
Time to minimum value
Standard deviation
Peak-to-peak valu
e
Period
Area value
Maximum value
Frequency
X-Y area value
For details on the various calculation functions, refer to Section 21.3.8
Screen: STATUS3 (MEM
)
Move the flashing cursor to the position
shown in the figure on the left.
Use the function keys or the JOG control
to make the selection.
Method
Method
Selection
Selection
：Channel number up.
：Channel number down.
NOTE
Parameter calculation settings
Calculation channel settings
・Also when "ALL" is selected, channels where no units are installed, a
channel that deviates from the set active channel range and channels for
which display/record is set to "OFF" will not be calculated.
・When the X-Y area value is selected in parameter calculation, channels on
the X and Y axes should be specified. "ALL" cannot be selected.
・Even if the display format is not the X-Y screen, the X-Y area value can be
selected.