User Manual

405
────────────────────────────────────────────────────
15.2 Using the Multi-Block Function
────────────────────────────────────────────────────
：Move the cursor up in the selection
window.
：Move the cursor down in the
selection window.
Move the flashing cursor to the position
shown in the figure on the left.
Use the JOG control or the function keys
to make the selection.
Selection
Selection
When the recording length is set to the arbitrary
recording-length mode, recording-length setting
cannot be performed on the memory
segmentation screen.
When the recording length is changed to one
for which memory segmentation is not permitte
d
on the STATUS1 or the DISPLAY screen, multi
-
block saving is automatically set to OFF.
(3) Setting the Recording Length
DIV
Number of channel
32 ch 16 ch 8ch 4ch
3 1000 2000 5000 10000
7 500 1000 2000 5000
15 200 500 1000 2000
31 100 200 500 1000
63 50 100 200 500
127 25 50 100 200
255 − 25 50 100
DIV
Number of channel
32 ch 16 ch 8ch 4ch
3 5000 10000 20000 40000
7 2000 5000 10000 20000
15 1000 2000 5000 10000
31 500 1000 2000 5000
63 200 500 1000 2000
127 100 200 500 1000
255 50 100 200 500
M
aximum recording length (16 MW
)
M
aximum recording length (64 MW
)
NOTE
■ The maximum number of divisions and the maximum recording length are
automatically determined according to the set memory capacity and number of
available channels, as shown in the tables below. See Section 12.2.1 about
setting of the use channel.
When using the multi-block function, the number of memory blocks has
priority over the recording length (DIV). When the number of memory blocks
is changed, the recording length may automatically be adjusted.