User Manual

403
────────────────────────────────────────────────────
15.2 Using the Multi-Block Function
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
(2) Any block can be called u
p
on display
(1) Store in memor
y
(3) Overlayed display of
data from 2 blocks
(3) Displaying arbitrary blocks in duplicate
Save at least two waveform data items.
Select the block to be used to display
waveform data, from among the recorded
blocks on the "use block" menu.
Select the block to be to displayed in
duplicate on the "ref block" menu.
Display the block selected from the "use
block" menu and the block selected from the
"ref block" menu, in duplicate.
Note that waveform data cannot be saved
while blocks are overlapping.
(2) Displaying an arbitrary block
Select the block to be used to display the
waveform data, from among the recorded
blocks on the "use block" menu.
(1) Recording the waveform data in an
arbitrary block
Set the number of memory divisions.
Select the block to be used for saving the
waveform data, from among the divided
blocks on the "use block" menu.
Press the START key to conduct
measurement and save waveform data to
the specified block.
1
5.2 Using the Multi-Block Function
・Memory is divided into blocks which can be freely selected by the user for
storing measurement data.
・Data stored in any block can be called up on the display.
・Data from different blocks can be overlayed on screen for easy comparison. (it
can be printed out)