User Manual

401
────────────────────────────────────────────────────
15.1 Using the Sequential Save Function (MEM)
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
：After all blocks are recorded, the
waveform of the last block only is
displayed.
：Each block is recorded and
displayed.
Waveforms acquired for each block by
triggering during the sequential saving process
are displayed one by one.
(As a result, the dead time is increased.)
Move the flashing cursor to the
wave display item, as shown in the figure
on the left.
Use the the function keys to make the
selection.
Selection
Selection
(MEM only
)
(6) Setting the follow-up waveform display
(7) Set the ref block.
Select a memory block whose waveform data
are to be overlaid on screen with the memory
block selected for display. The recording start
time and time axis range are displayed on the
window.
Move the flashing cursor to the ref block
item.
Use the function keys to make the
selection.
：Disable ref block
：Enable ref block
：Turns off all ref block settings.
：Sets all blocks as ref blocks.
Move the flashing cursor to the numerical
value item (ref block).
Ref block settings can be made one block
at a time. Blocks set as ref blocks are
marked with an asterisks.
：Increases in number.
：Decreases in number.
：Enable ref block
：Disable ref block
NOTE
・The colored blocks indicate that measured data has ben saved to the blocks.
・The displayed block settings and block status are shown on the display
screen. (See Section 11.6.)