User Manual

400
────────────────────────────────────────────────────
15.1 Using the Sequential Save Function (MEM)
────────────────────────────────────────────────────
Move the flashing cursor to the use block
item, as shown in the figure on the left.
Use the JOG/SHUTTLE control or the
function keys to make the selection.
：Value up.
：Value down.
Selection
Selection
After measurement starts, the displayed block i
s
updated by the recorded block.
When measurement is completed, the most
recently recorded block is displayed.
(3) Display block setting
Move the flashing cursor to the start block
item, as shown in the figure on the left.
Use the JOG/SHUTTLE control or the
function keys to make the selection.
：Value up.
：Value down.
Selection
Selection
(4) Start block setting
Move the flashing cursor to the end block
item, as shown in the figure on the left.
Use the JOG/SHUTTLE control or the
function keys to make the selection.
：Value up.
：Value down.
Selection
Selection
(5) End block setting