User Manual

375
────────────────────────────────────────────────────
14.7 SAVE
────────────────────────────────────────────────────
1
4.7 SAVE
・Stores a file in the directory currently selected on the file screen.
・The waveform data can be stored as binary or text data. Data stored in the
text format is not readable by the 8826.
■ What can be recorded and how much
(1) Setting state (SET)
It is possible to record the setting state for each of the functions.
When a multiblock is used, the setup conditions of the use blocks are
stored.
When a setting state is read into the 8826, it is restored in the unit. (See
Section 14.8)
Size of recording for the setting state: 512×69 bytes＝35328 bytes
(2) Measurement data（MEM, REC, XYC, RMS, FFT, TXT）
It is possible to save the measurement data of a waveform which has
been captured.
Use of cursors A and B enables partial saving (excluding XYC, FFT).
When measurement data is read into the 8826, the waveform data
recorded on the media is put into the designated memory channel.
When the measurement data of a waveform is recorded, its setting state
(the recording length, time axis, measurement range, scaling and
comments) is also simultaneously recorded. Because when this is loaded
the unit is set to the condition when the measurement data was recorded,
it can be checked by being listed.
Logic channels ch1 to ch4 are considered as one channel in any function.
For the size of a file, see Section 21.4.1 and 21.4.2.
(3) Recorder and memory (R_M)
In this function, the recorder waveform and memory waveform can be
saved.
These waveforms can be saved in a single operation.
(4) Memory block (SEQ: sequential, MUL: multiblock)
Using the memory segmentation function, the recorded waveform data
can be saved to the memory block.
Batch saving of all blocks can be selected.
(5) Evaluation area (AREA)
The area created using the waveform evaluation editor can be saved.
The setup conditions are saved together with the evaluation area.
The recording capacity varies depending on the evaluation area.