User Manual

368
────────────────────────────────────────────────────
14.3 PC Card
────────────────────────────────────────────────────
1
4.3.1 Using the PC Card Slot (PC Card with a Cable Only)
CAUTIO
N
If a PC card is inserted upside down, backwards, or in the wrong direction, the
PC card or the unit may suffer damage.
To avoid damage to the PC card or connector, observe the cautions listed
below.
・Inserting the card with the wrong orientation or in other ways than described
above.
・Inserting the card while attached to the connection cable.
・Moving the 8826 while the connection cable is connected to the card.
・Pulling the card out by the cable or exerting excessive force on the
connector.
・Placing objects on the connection cable connector.
Connection cabl
e
Front marking
s
PCMCIA socket sid
e
Locking Connector
Locking sprin
g
Protecto
r
Eject butto
n
■ Cable and PC card connection
(1) Pass the PC card protector through the connection cable, as shown below.
(2) Plug the PC card end of the connection cable into the PC card. The top side
of the cable connector (marked with a ▲) should match the top side of the
PC card, as shown below.
(3) Insert the PC card in the PC card slot on the 8826. Verify that the ▲ mark
on the card points in the correct direction as shown below, and make sure
that the card is properly seated in the slot. The PC card is keyed to prevent
wrong insertion, but exerting excessive force may damage the card or the
slot.
(4) Attach the PC card protector to the 8826 as shown below.
■ Removing the PC card
(1) Remove the PC card protector.
(2) To remove the PC card, press the eject button.
Do not press the eject button before removing the PC card protector.