User Manual

357
────────────────────────────────────────────────────
13.6 Printing Procedure
────────────────────────────────────────────────────
1
3.6.3 Real-Time Print
Screen: STATUS
Press the STATUS key to call up the
STATUS screen.
Move the flashing cursor to the printer item
,
as shown in the figure on the left.
Use the function keys to make the
selection.
：Disable real-time print print
：Enable real-time print print
Selection
Selection
Method
Method
When measurement starts, waveform
appears on screen and printout starts.
NOTE
The input waveform and data are printed out continuously in real time (REC,
RMS, and REC&MEM).
・In the REC and RMS function, at a time axis range setting of 200 ms/DIV or
faster, the waveform data will be printed out later. (See Section 18.5)
・In the REC&MEM function, at a time axis range setting of 20 ms/DIV to
200 ms/DIV, the waveform data will be printed out later.
・While the printer always outputs the data at the measurement
magnification in recording mode, the waveform on the screen is reduced in
size at the ratio shown below, depending on the time-axis range.
REC: 50 ms/DIV ×1/2, 20 ms/DIV ×1/10
REC&MEM: 100 ms/DIV ×1/2, 50 ms/DIV ×1/5, 20 ms/DIV ×1/10