User Manual

356

────────────────────────────────────────────────────

13.6 Printing Procedure

────────────────────────────────────────────────────

3.6.2 Auto Print

Screen: STATUS1 (MEM

)

: STATUS2 (FFT)

Press the STATUS key to call up the

STATUS1 screen.

Move the flashing cursor to the auto print

item, as shown in the figure on the left.

Use the function keys to make the

selection

：Disable auto print

：Enable auto print

Selection

Method

Press the START key to start the

measurement.

Printout is carried out automatically after

a waveform has been captured for the

specified recording length.

・ When COMMUNI is selected, you can

transfer print images to the 9333 LAN

COMMUNICATOR.

NOTE

Printout is carried out automatically after a waveform has been captured for

the specified recording length (MEM and FFT).

・When cursors A and B are enabled, partial printing is executed (MEM).

・When the local mode is enabled and the time-axis range is lower than 10

ms/division, data is displayed and printed simultaneously (MEM).

・When both auto-print and auto-save are enabled in memory recorder

function, auto-save usually takes precedence. However, if roll mode is

enabled, auto-print will execute first.