User Manual

11
────────────────────────────────────────────────────
2.2 Power Supply and Ground Connection
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
1
0
1
1
1
2
1
3
1
4
A
WARNIN
G
Check the following points before connecting the unit to a power
supply. Take care never to exceed the power supply ratings given
below, to avoid the risk of electric shock and damage to the unit.
Power supply matches Rated supply voltage (100 to 240 V AC: Voltage
fluctuations of 10% from the rated supply voltage are taken into
account.) and rated supply frequency (50/60 Hz).
The AC power switch of the 8826 are set to OFF.
Use only the supplied AC power cord.
The 8826 has no protective ground terminal, but is intended to be
connected to a ground wire via the grounded three-core power cord
supplied. In order to avoid electric shock accidents, be sure to connect
the grounded three-core power cord supplied to a power supply socket
one of whose terminals is properly grounded.
CAUTIO
N
The microgap power switch construction necessitates that the product
be used near a power outlet. When not in use and while making
connections to the circuit to be tested, disconnect the product from the
power source by unplugging it from the outlet.
NOTE
2
.2 Power Supply and Ground Connection
(1) Verify that the AC power switch of the 8826 is set to OFF.
(2) Plug the grounded three-core power cord supplied into the AC power
connector on the right side of the 8826.
(3) Plug the power cord into an AC outlet corresponding to the rating of the
8826.
The fuse is incorporated in power supply. It is not user-replaceable. If a
problem is found, contact your nearest dealer.