User Manual

343
────────────────────────────────────────────────────
13.4 Setting the SYSTEM Screen (printout)
────────────────────────────────────────────────────
：Displays the time from the trigger point (unit: fixed).
：Displays the time from the trigger point (unit: base 60).
Selection
Selection
：Displays the number of DIV from trigger point.
：Displays the time when a waveform is captured.
：No gauges or listing
：Print listing only
Selection
Selection
：Print gauges only
：Print both gauges and listing
Selection
Selection
：Upper-lower print is not used.
：Upper-lower print is used.
Selection
Selection
：0 position comment is not used.
：0 position comment is used.
Selection
Selection
Time Value
The time from the trigger point and other information can be printed.
List & Gauge
When a waveform is printed out (except for screen hard copies), the gauge can
be printed out at the beginning, and a listing can be printed out at the end.
On the wide X-Y screen, the horizontal axis gauge is not printed out.
Printer Density
Serves to set the printer density. Select the setting which yields the most
easy to read printout.
Upper-lower Print
In waveform printing, the upper and lower values of each channel are printed
first. When the scaling function is being used, the scaled values are printed.
0 Position Comment
In waveform printing, comments are printed out in the zero position of each
channel. This comment printing is valid only for the analog channels.
Comments can be set on SYSTEM3 (COMMENT) screen.