User Manual

338
────────────────────────────────────────────────────
13.2 Setting the STATUS Screen (printout)
────────────────────────────────────────────────────
Screen: STATUS
Press the STATUS key to call up the
STATUS screen.
Move the flashing cursor to the print mode
item, as shown in the figure on the left
Use the function keys to select LOGGING.
：Measurement data and the result o
f
calculation are printed as a
waveform.
：Measurement data and the result o
f
calculation are printed as numeric
data.
Selection
Selection
Method
Method
When the numeric data format is selected,
set the print interval.
Move the flashing cursor to the interval
item.
Use the JOG control or the function keys
to select the print interval.
：Move the cursor up in the selection
window.
：Move the cursor down in the
selection window.
Selection
Selection
(1) Setting the Print mode
(2) Setting the print interval
NOTE
Printing as numeric data
・When the print interval longer than the recording length is set, only the
first dot is printed.
・Since each division equals 100 samples, the print interval "0.01" indicates
one sample (no print interval).
・When recorder function or RMS recorder function, the maximum and
minimum values are printed (see Section 21.3.4 or 21.3.5).
The print intervals of 0.01 to 0.5 DIV can be selected, only when there are
waveform data present.