User Manual

337
────────────────────────────────────────────────────
13.2 Setting the STATUS Screen (printout)
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
1
3.2.2 Setting the Print Mode
Screen: STATUS
Press the STATUS key to call up the
STATUS screen.
Move the flashing cursor to the print mode
item, as shown in the figure on the left.
Use the function keys to select WAVE.
：Measurement data and the result o
f
calculation are printed as a
waveform.
：Measurement data and the result o
f
calculation are printed as numeric
data.
Selection
Selection
Method
Method
When the waveform format is selected,
determine whether to use the smooth
printing or not.
Move the flashing cursor to the
smooth print item.
Use the function keys to make the
selection.
：Normal printing is carried out.
：Smooth printing is enabled.
Selection
Selection
(1) Setting the Print mode
(2) Setting the Smooth printing
NOTE
Select the format, waveform, or numerical value should be used to output
measured data and calculation results.
Waveform：The smooth print function can be used, but print speed will
decrease. (MEM and REC&MEM only)
Numerical value：The data spacing interval also must be set.
Printing as a waveform
・On X-Y screen, smooth printing cannot be specified.
・In the REC and REC&MEM, the trigger mark (
) is written as the start
position mark. In an additional recording, the trigger mark is displayed in
front of the most recently entered data.