User Manual

325
────────────────────────────────────────────────────
12.5 INTERFACE Screen (SYSTEM 4)
────────────────────────────────────────────────────
When setting up a network when only using a PC and recorders, not
connecting to an existing network, for example, set the parameters as shown
below.
IP address of PC : 192.168.0.1
IP address of 1st recorder : 192.168.0.2
2nd : 192.168.0.3
3rd : 192.168.0.4
4th : 192. 168.0.5
↓ ↓
Host name : Enter the desired name (each host name must be unique).
Subnet mask : 255.255.255.0
Gateway : OFF
DHCP : OFF
DNS : OFF
Port No. : 880x
Setting Individual Parameters
Once the LAN card is inserted, setting parameters appear on the SYSTEM 4
INTERFACE screen as shown below. Move the cursor to a parameter you want to
set up. After making all necessary setting changes, press
F5 [Enter] to
confirm. Otherwise, the changes will not be reflected.
Host Name
Set the name to represent the 8826 on the network. Choose a unique name
that is different from those of other devices on the network. When using the
9333 LAN COMMUNICATOR, note that the host name is used to identify a
directory on the PC.
Dynamic DNS is not supported and therefore the set host name will not be
registered in DNS.
IP Address
Set the IP address of the 8826.
The IP address is used to identify individual devices on a network. Set a
unique address that is different from those of other devices on the network.
When DHCP is ON, it automatically sets the IP address.
Subnet Mask
Subnet mask is used to divide an IP address into a network address and host
address. Set the subnet mask the same way that subnet masks of other
devices on the network are set up.