User Manual

322
────────────────────────────────────────────────────
12.5 INTERFACE Screen (SYSTEM 4)
────────────────────────────────────────────────────
1
2.5.4 Setting the SCSI ID and Target ID
NOTE
1
2.5.5 Setting the MO Drive
NOTE
1
2.5.6 Setting the LAN Interface
Set the SCSI interface. For details, refer to 14.4.
SCSI ID
Set the ID number of the 8826 on the SCSI bus.
The available value range is 0 to 7.
Target ID
Set the ID number of the MO drive, which will be connected to the 8826, on
the SCSI bus. The ID number of the internal MO drive (optional) is set to 4.
Therefore, if the internal MO drive has been mounted, the ID number 4
cannot be specified. The available value range is 0 to 7.
・Do not set the SCSI ID and target ID to the same number.
・When "SCSI" or "MO" is selected as the output destination, separate
destinations cannot be set for the auto save, parameter calculation result
save, and COPY key output.
The 8826 internal MO drive can be used as an MO drive on a PC.
Internal MO drive settings are valid only when the optional 9598 MO Unit is
installed.For details, refer to 14.2.1.
・The ID of the internal MO drive is fixed at 4, and cannot be changed.
・When the internal MO setting is ON, the "Internal MO" media selection is
not available.
・When the internal MO setting is ON and if "Internal MO" is selected as the
destination for automatic saving, Auto Save settings are OFF.
■ LAN Interface
The 8826 MEMORY HiCORDERs provide the LAN functions below by using a
LAN card inserted in the PC card slot.
Supporting the 9333
When using the HIOKI 9333 LAN COMMUNICATOR, you can remotely
control the 8826 on a PC or use the Auto Save function to save 8826 data on a
PC via the 9333. For details, refer to the instruction manual provided with the
9333.